1) Monitor face up, remove CRT bezel.
2) Unplug touchscreen jumper socket.
3) Remove 2 screws above CRT
4) Refit Bezel
5) Monitor face down, remove 4 screws on bottom.
Front 2 self-tapping + washers, rear 2 machine + washers
6) Lift off case
7) Remove inspection cover under PCB (4 screws)
8) Remove cable tie at front right.
9) Undo 3 front panel screws. Move panel to right of chassis
10) Pull off control knobs. Undo 2 control bracket screws. Set panel aside
11) Unplug mains input, switch and transformer from PCB
12) Remove mains earth (nut, lockwasher, PCB earth wire,
nut,lockwasher, mains earth, lockwasher, screw+ washer
13) Remove mains switch (2 screws)
14) Unclip touchscreen connector
15) Unscrew speaker bracket
16) Discharge CRT to front right earth bolt, remove anode cap
17) Remove top nut, lockwasher, PCB earth wire from front right earth bolt
18) Unplug yoke connectors
19) Unplug CRT base
20) Remove rear right earth bolt (CRT base earth)
21) Remove voltage selector from rear apron (2 screws)
22) Remove rear apron (3 screws
23) Unplug socket from 12V regulator (red wire on top)
24) Unbolt mains transformer
25) Remove PCB